|
| SPECIFICATIONS |
Output |
|
|
Output impedance | 75 ohms | RCA SPDIF |
| 110 ohms | XLR AES/EBU |
Output | RCA output | 0.7 V |
| XLR output | 5V peak to peak nominal (balanced) |
| 44.1kHz | |
Connections |
|
|
Digital outputs | 1 RCA coaxial connector SPDIF | |
| 1 TOSLINK optical connector | |
| 1 XLR AES/EBU balanced digital output | |
Trigger input | 3.5mm (⅛”) mono jack ±4.5 to ±15V DC | |
Trigger output | 3.5mm (⅛”) mono jack ±4.5 to ±15V DC | |
Power requirement |
|
|
Mains voltages | ||
Consumption | 10 Watts maximum | |
Weight |
|
|
Unit only, unboxed | 3.5 kg (7¾ lbs) |
|
In shipping carton & inc. accessories | 4.0 kg (8⅞ lbs) |
|
Dimensions |
|
|
Wide | 220 mm (8⅔”) |
|
High, including feet | 100 mm (4”) |
|
Deep (front to back) including terminals | 300 mm (12”) |
|
Standard accessories
IEC type mains lead
M1 CDT remote control
Batteries, LR03 or AAA, manganese alkaline type - 2 off
Musical Fidelity reserves the right to make improvements which may result in specification or feature changes without notice.
M1 CDT manual issue 2 | Page 16 of 17 |
GENERAL ADVICE
Installation, Precautions & User Information
This new M1CDT is designed and built to provide
•Heed all warnings shown on the back of the product.
•Only connect the M1CDT to a mains outlet having the same voltage as marked at the back of the unit.
•Always ensure that when disconnecting and reconnecting your audio equipment the mains supply is switched off.
•Position the mains lead and signal interconnects where they are not likely to be walked on or trapped by items placed on them.
•Do not use near water, or place
•Do not place the unit near direct heat sources such as radiators, direct sunlight or other equipment.
•Do not remove any covers or try to gain access to the inside. There are no user adjustments or fuses to
change without qualification. Refer all service work to an authorised Musical Fidelity agent.
*Note: Unauthorised opening of the equipment will invalidate any warranty claim.
•Dust regularly with a soft cloth or soft brush but be careful when using cleaning or polishing agents - they may harm the surface finish.
The electronics in modern
If
M1 CDT manual issue 2 | Page 5 of 17 |