type, each finger print has a central area around which the remainder of the pattern is distributed. This central area is the core of the finger print. Best performance is achieved when the core of the finger print is placed in the center of the sensor detection surface. It is essential to place the core of finger print inside the sensor area to obtain a successful image capture of the finger print.
It is most advisable in real practice to register (enroll) for each ID more than 1 finger and even better to register fingers from both hands into the system. In this way, the identification procedure can less likely be obstructed even in case of accidental injury. Please note that the finger print sensor is not suitable for taking the finger print image of an infant.
Please refer to the readme files in the software installation for further detail or consult our web site http://www.posiflex.com.tw
MAGNETIC STRIPE READER
The regular magnetic stripe reader in KP100 or KB4000 connects to the host through KB port and therefore requires no driver installation to get it working. The regular magnetic stripe reader in SD100 connects to the host through USB port working as a USB KB and therefore also requires no driver installation except setting up the USB keyboard to be enabled in system CMOS setup. However for the special MSR type in SD100 that utilizes a MSR connector, it relies on the controller inside the MSR port of the host to consolidate the MSR data into KB port of the system.
Besides the interface options there are also reader head options applicable to MSR in these security devices. The reader head can be JIS II type or one of the possible configurations in ISO standard (tracks 1 & 2, 2 & 3, 1 & 2 & 3). For ISO MSR, some parameters on data readout can be set by jumper setting or by software provided by Posiflex as below. For MSR to read card of AAMVA and CA DMV, the reader head must be 3 tracks ISO type and it must be on KB4000 or KP100 or it has to be the USB interface type in SD100.
2 | 12 |
| To manipulate the ISO MSR |
CN3 1 | JP1 11 | CN2 CN1 in SD100, one has to alter the jumper | |
U5 | U3 | U1 | settings on the controller board in the |
|
KB4000 Series User’s Manual | 3 - 2 |