NAD C 445 Installation And Connections, Audio Connections, Audio Equipment Connections

AUDIO CONNECTIONS

After unpacking the unit and placing it on a solid surface capable of supporting its weight, you will need to make the connections to your pre amplifier or integrated amplifier. These steps need to be done only when the tuner is first installed.

AUDIO EQUIPMENT CONNECTIONS

We recommend that you use high-quality interconnect cables when making connections to source equipment and recorders to preserve the quality of the signals.

When making connections to audio source equipment it is always a good practice to unplug the unit from the AC wall outlet. This prevents any possibility of accidentally sending audio or transient signals to the speakers that may damage them.

1Connect the analogue output of the C445 to the tuner input of your pre amplifier or integrated amplifier.

2For DAB signals, connect the optical digital output of the C445 Tuner to an optical digital audio input of your pre amplifier or integrated amplifier, if available.

3Assemble the AM Loop Antenna supplied with the unit as shown below.

Connect it to the AM terminals.

4Connect an FM Antenna to the FM Antenna connection. The FM antenna may be an external roof antenna, an inside powered or wire lead antenna or a connection from a cable system. Note that if the antenna or connection uses 300-ohm twin-lead cable, you need to use a 300-ohm-to-75-ohm adaptor to make the connection. The supplied antenna is for indoor use only.

5Connect a DAB Antenna to the DAB Antenna connection. The supplied antenna is for internal use only. Fix it to the wall in a vertical direction. The strength of the incoming signal can be shown on the Information Display by pressing the Select button. The more segments are visible in the lower display line, the stronger the signal. By changing the position of the antenna, you can increase the signal strength. You can also opt for an external antenna, available at your dealer.

For best reception place the unit as far as possible from sources of RF emissions such as a television or computer. It should also be placed away from contact with any metal object. In areas where signals are weak, an outdoor antenna may improve sound and reception quality. Connect the antenna making certain to also connect a ground wire to the GND (ground) terminals.

Introduction

INSTALLATION AND CONNECTIONS

DAB ANTENNA

DAB AND FM VHF EXTERNAL ANTENNA

When all connections are complete, plug the power cord into a non- switched 230 Volt AC For best reception, place the antenna away from wall outlet.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

9