Example
With just pressing Macro for AMP as device, you wish to switch on your AV receiver, TV and DVD player; select the Video 1 input on the receiver and activate Play on the DVD player.
1Press the POWER ON/OFF (No. 2) and MUTE keys (No. 14) together for approximately 2 seconds until STATUS LED (No.1) stays red.
2Press the required AMP DEVICE key (No.3); the AMP key will light up.
3Using the numeric
4Record the Macro by selecting the functions:
•Press POWER ON/OFF (No.2) (command for switching on AV receiver).
•Press SHIFT (No. 9); the STATUS LED changes to green. Press the TUNER/TV device key (No.3). The STATUS LED will change to red again. Press POWER ON/OFF (command for switching on TV).
•Press DVD Device key; press POWER ON/OFF (command for switching on DVD player).
•Press AMP Device key; press VIDEO 1 (inside No. 10) (command for switching AV receiver to Video 1 input).
•Press DVD Device key; press PLAY/ENTER (No. 16) (command for activating Play on DVD player.
5Press the Macro key (No. 23) to store the Macro. The STATUS LED and DEVICE key will go out and the Macro is programmed.
To play back a Macro, select the required device and press Macro. The macro is now executed, for each remote command send in succession, the corresponding DEVICE key will light up briefly.
NOTE
RESET TO FACTORY DEFAULT SETTINGS
Sometimes it may be necessary to reset the
TO RESET THE NAD HTR-1
Press the POWER ON/OFF (No. 2) and SELECT keys (No. 6) together for approximately 5 seconds until STATUS LED (no.1) flashes twice.
NOTE
When you reset the remote to factory default settings, you will LOOSE ALL SETTINGS AND LEARNED REMOTE COMMANDS; ONCE ACTIVATED, RESET CAN NOT BE UNDONE!
GB
11
