NAD T585 Rear Panel North American Version, IR in Jack, Digital OUT Coaxial Jack, Power on /OFF

T585 Safety.qxd 3/23/2006 4:12 PM Page 7

Identification of Controls

REAR PANEL (NORTH AMERICAN VERSION)

1	IR IN Jack	10	HDMI OUT Jack (480/576, 720p, and 1080i video resolutions)
2	DIGITAL OUT COAXIAL Jack	11	VGA OUT Jack (480/576, 720p, and 1080i video resolutions)
3	DIGITAL OUT OPTICAL jack	12	AUTO TRIGGER ON/OFF Switch
4	MIXED AUDIO OUT (L & R) Jacks	13	+12V TRIGGER IN jack
5	5.1 CH AUDIO OUT FRONT L & R Jacks	14	Power cord socket
6	5.1 CH AUDIO OUT CENTER and SUBW (Subwoofer) Jacks	15	POWER ON/OFF
7	5.1 CH AUDIO OUT SURR (Surround Sound) L & R Jacks	16	RS 232 In/Out Jack

8S-VIDEO& Composite VIDEO OUT Jacks (480i/576i video resolutions)

9COMPONENT VIDEO OUT Jacks (480i/576i, 480p/576p, and 1080i video resolutions)

NOTES

Connect the optical digital cable (not supplied) firmly so that the configurations of both the cable and the connector match.

The +12V TRIGGER IN jack is a 3.5mm monotype miniature phone jack with the centre pin the 12V signal-sense. We recommend that you use a good quality cable with shield when attaching the 3.5mm monotype plug so as to prevent false triggering of the amplifier due to electro- magnetic interference from nearby electronic equipment. The +12V-IN TRIGGER allows you to have an external 12V signal to turn ON the NAD T585 from standby. This 12V signal must be a continuous 12V signal in order to keep the T585 in the ON state. Once you remove the 12V signal the T585 will return to standby. Check the specifications of the trigger input terminal the other components to ensure these are compatible with the T585. All 12V-TRIGGER inputs and outputs on other NAD components with a 12V-TRIGGER feature are fully compatible with the NAD T585’s 12V-TRIGGER IN. Before making any connections to any 12V-TRIGGER IN make sure all components are disconnected from the AC mains. If in doubt over the connections, installation and/or operation of the 12V-TRIGGER IN connection, consult your NAD dealer or sales representative. Failure to observe the above may result in damage to the NAD T585 and/or any ancillary components attached to it.

The IR IN jack is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow control of the T585 from a remote location. Ask your dealer or custom installer for further details

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

7