NAD T752 owner manual Quickstart, Play A Dvd Movie, English

QUICKSTART

In case you simply cannot wait to experience the performance of your new NAD T 752 receiver, we provide the following “Quickstart” instructions to get you underway. The steps below connect your DVD player to the T 752’s DVD input; be sure to read “Input Setup”, below.

PLAY A DVD MOVIE

•Connect the T 752’s composite video or S-Video MONITOR OUT jack to your TV/monitor’s corresponding input.

•Connect your DVD player’s composite video or S-Video output to the T 752’s corresponding DVD input.

•Connect the DVD player’s optical digital output to the T 752’s optical DIGITAL IN 1 input.

•Connect your left and right front speakers to the T 752’s FRONT L and R outputs, being sure to connect red to red (“+”) and black to black (“-”), with care to avoid stray wires or strands crossing between terminals. (Connect center and surround speakers as well, if you like). If your system includes a powered subwoofer, connect the T 752’s AUDIO PRE-OUT SW1 jack to its line input.

•Press in the main power switch (green pushbutton) on the T 752’s front panel (this puts the T 752 into STANDBY mode and illuminates an amber LED to indicate it is ready to receive remote commands), then use the HTR 2’s [ON] key to power up the receiver. Be sure the TV/monitor is powered up, with the correct input selected.

•Start playback of the DVD player. Press the HTR 2 remote’s [Amp] Device Selector key, and then its (red) DVD/numeric 1 key to select the DVD input. You should hear multichannel or stereo sound, and see an image on the TV/monitor. (If one or the other fails to appear, you may need to use the receiver’s on-screen menu system to check assignment of audio, video, and digital inputs; see “Configuring the T 752”, below.)

Enjoy the movie or music, but be sure to set aside time to read this manual thoroughly, and to set up, calibrate, and configure your T 752 carefully and completely.

ENGLISH

9