Nady Systems SDR-260 owner manual E R At I O N

O P E R AT I O N

GETTING STARTED

Set the INPUT VOLTAGE SELECT SWITCH (8) for either ~115V(60Hz) or ~230V(50Hz) AC power. Attach the power cord and plug it in.

Connect the Input and Output signals from the SDR-260 to your audio system with the appropriate XLR balanced or 1/4” unbalanced INPUT and OUTPUT JACKS (11, 13, 14, 16), depending on the type of cable and connectors you’re using. For Mono input use the Left channel input connector. XLR output is disconnected when output 1/4” jack is inserted.

Turn the POWER SWITCH (7) On. You will see the preset Program number [P 1] on the VALUE INDICATOR (3).

ADJUSTING LEVELS

Adjust the INPUT GAIN CONTROL (1) for the highest setting without the red top L/R LED indicators of the INPUT LEVEL DISPLAY (2) staying on continuously. Occasional flickering of these red LED indicators is normal.

The INPUT LEVEL SWITCH (15) and OUTPUT LEVEL SWITCH (12) are provided to adjust the levels for the optimum performance. Adjust the level controls to minimum noise and distortion while operating with the components of your sound system.

MODE SELECTION

Pressing the ROTARY CONTROL KNOB (6) quickly will cycle the modes from “P” Preset programs [P1-P60], to “U” User programs [U1-U60] where custom programs are stored, to finally PAS where the effects are bypassed.

BYPASS EFFECTS

The effects are disabled in the “PAS” mode.

SELECTING EFFECTS

In the Preset programs mode there are 60 preset effects, select one by rotating the ROTARY CONTROL KNOB (6) through the sixty choices. Stop at the desired choice and the audio will mute briefly while the program is loaded. See Preset PROGRAM LISTING of effects on the front panel.

In the User mode there are 60 locations for custom effects, select one by entering the User mode and rotating the knob through the sixty choices.

CUSTOM EFFECTS

Custom effects are modified preset programs. There are 60 locations for storing custom effects. Enter the Edit mode by holding the ROTARY CONTROL KNOB (6) in for 3 seconds. The display will show the value of the program parameter. Rotating the knob will raise or lower the program sub- category parameter value. Pressing the knob quickly will cycle the sub-categories DELAY (1-250mS), REV (1-99%), HI- PATIO (0.1-1.0), ER-LVL (1-99). After adjusting the parameter values for the desired sound the custom effect can be stored. Holding the knob in for 3 seconds will enter STORE mode. The Save LED and the “U” will flash; rotate the knob to select the storage location [U1-U60]. To complete the STORE process, Hold the knob in for 3 seconds, the STORE LED will blink twice indicating the changes have been stored. To cancel the STORE process press and release the knob quickly.

REMOTE CONTROL USING MIDI

Connect the SDR-260 to the MIDI controller via the rear panel MIDI INPUT (10) connector.

Receives MIDI Program Messages on MIDI Channel 1.

Prgm Mess. 1-60 for Preset Programs 1-60

Prgm Mess. 61-120 for User Programs 1-60

Prgm Mess. 121 for Bypass Mode

6