Nady Systems U-1000 owner manual System Operation

SYSTEM OPERATION

(Note: The UH transmitter CAP (7) must be removed before installing the USB

cable.) (Note: Only one transmitter can be used with one UHF-1000 receiver. It is not possible to use two transmitters on the same frequency and mix the output of these transmitters into one wireless receiver. If you have any questions, please contact the Nady Systems Customer Service Department. See SERVICE section, pg. 21.)

CAUTIONS AND TROUBLESHOOTING

Feedback

Observe care in selecting P.A. volume, transmitter location and speaker placement so that acoustic feedback, howling and screeching, will be avoided. Please also note the pickup pattern characteristics of the microphone selected. Omni directional mics pick up sound equally from all directions, and are prone to feedback if not used carefully. Unidirectional mics are more resistant to feedback, but pick up sound sources best that are directly in front of the mic. Also, mics that are farther from the sound source, such as lavaliers, require more acoustic gain and thus are also more prone to feedback than close-source mics such as handheld or headworn models that are used close to the mouth.

Microphone Damage

Headset and lavalier mic users, note that the microphone element can easily be destroyed by the buildup of salts and minerals from perspiration and saliva. It is good practice to put a windscreen on the mic at all times to protect it.

No Audio

If you’re not getting audio through the system, carefully check all setup. The receiver and transmitter must be set to operate on the same RF channel.

RF Interference

If you encounter receiving interference (from other than an operating TV station), often it can be overcome by adjusting the receiver’s squelch control. Please note that wireless frequencies are shared with other radio services. According to FCC regulations, wireless microphone operations are unprotected from interference from other licensed operations in the band. If any interference is received by any Government or non-Government operation, the wireless microphone must cease operation or change frequencies. The above statement is valid only for use in the U.S.A.

OPERATING INSTRUCTIONS

UH-1000 Handheld Microphone

TRANSMITTERS SETUP

Installing Batteries

UH-1000 transmitters require 2 “AA “ size batteries to operate. Insert the batteries according to the correct polarity as indicated. To open the battery compartment, press the release latch and open the cover.

(CAUTION: Many batteries are known to have leakage problem of conductive and corrosive liquid. Please observe the rule to remove the batteries if they are not to be used for a period of a few days. This battery compartment is designed to accommodate the most common size Alkaline batteries.)

Powering the Transmitter

To turn ON, Press the POWER SWITCH (5), for 1 second.

The LCD DISPLAY (2) will flash the company and model number. Then the menu will appear.

To turn OFF, Press the POWER SWITCH (5) for 3 seconds and release. The transmitter will turn off.

Auto Turn Off function. If the transmitter Audio mute switch is in the OFF position and the transmitter is left On. It will turn OFF after 30 minutes. This foolproof feature will save the batteries.

Menu pages in Preset or User mode

Cycle Menu pages by pressing the UP (9) or DOWN (10) buttons.

Transmitter Setup Menus

Control Menus have two modes, Preset and User.

To make changes Hold the SET (8) button for 2 seconds and use the UP (9) or DOWN (10) buttons. To save changes hold the SET (8) button for 3 seconds.

The transmitter will remember the last Menu of User Name, Group and Channel, or User Edit, when it is turned off. That menu will appear when it is turned on.

1. User/Preset mode

In the Preset or User menu, hold the SET (8) button for 3 seconds. The curser will blink. Select from User or Preset with the UP

(9) or DOWN (10) buttons. After finishing the edit	USER MODE
hold the SET (8) button until the curser stops
	PRESET MODE
blinking.

18 7