Napco Security Technologies GEM-DXRP3 System Trouble Error Codes, E-04-NN, E-05-NN, E-06-NN, E-08

SYSTEM TROUBLE ERROR CODES

Trouble	System Trouble	Action
Indication	Condition
E-04-NN	Wireless Transmitter	A problem has been detected with a wireless transmitter. Call installing company for service.
	Supervisory Failure
E-05-NN	Wireless Transmitter	The battery in a wireless transmitter is low and should be replaced. This transmitter is on the zone
	Low Battery	corresponding to the number NN. The replacement battery for the GEM-TRANS2 door/window
		transmitter, GEM-PIR motion detector and GEM-GB glass break detector is the Duracell DL123A 3
		volt lithium. (2 required for the GEM-PIR and GEM-GB). The replacement battery for the GEM-SMK
		is the Duracell MN1604 9 Volt Alkaline(2 required). The GEM-DT Dual Technology Sensor requires 4
		C cell alkaline batteries.
		Warning: Replace batteries only with the same type as specified above. Use of another battery may
		present a risk of fire or explosion. Do not recharge or disassemble battery, or dispose of in fire.
E-06-NN	Receiver Response	Call installing company for service.
	Failure
E-07-00	Download Failure	Call installing company for service.
E-08	Telephone Line Cut	The telephone line has failed. If telephone service has been temporarily interrupted, the trouble will
		clear automatically when it is restored. Otherwise, call installing company for service.
E-09-00	System Cold Start
E-10-NN	Keypad Response	Call installing company for service.
	Failure

28