Napco Security Technologies GEM-DXRP3 Programming User Codes, Entering the User Program Mode

PROGRAMMING USER CODES

Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm the system, but also to enter the User Program Mode, where you can program other User Codes. The following explains how you will use this code to program or erase additional User Codes.

Entering the User Program Mode

1Enter your User Code, then press Ato enter the Function Mode.

2Answer NO (press F) until “17” (Activate Program) is displayed, then press YES (E) .

The display will scroll the following: “P” (Program mode); 4 digits identifying software versions; then “UP” (User Program). The keypad lights will flash while in the User Program Mode.

Programming / Reprogramming a User Code

1Press A, followed by the the 2 digits of the user number to be programmed ( Example: for User 4, enter 04).

2Press A, followed by the new User Code. Note: User Codes may be up to 6 digits in length. For User Codes shorter than 6 digits, use G0for remaining digits.

3Press Arepeatedly until “UP” is displayed.

4Press J to save the new User Code. Note: Duplicate Codes are not allowed; therefore a duplicate Code entered in the LCD

Window will erase when J is pressed. Repeat Steps 1 through 4 for each User Code to be programmed.

Erasing a User Code

To erase a User Code, press A, the 2-digit user number, Afollowed by G0until “UP” is displayed, then J.

•Example: Erase User 3’s User Code:

Press A03AG0G0G0G0G0G0(“UP” will display) J.

Reviewing a Programmed User Code

To review a User Code, press A, the 2-digit user number and Ato step through and review each digit of code.

22