8
LIGHT REPLACEMENT
There are two methods to replace the light:
In either method, the electrical circuit breaker must be shut off until the replacement procedure has been com- pleted at which time it can be turned back on.
Light Bulb Replacement Method 1:
1.If the unit is not secured to the floor, turn the unit around to view the access panel.
2.Remove the four screws securing the access panel.
3.Remove the light bulb by holding one of the wires and moving the light bulb to the opposite side of the wire that you are holding.
4.Replace using the new light bulb by following the re- moval instructions in reverse.
5.Replace the access panel and put the fireplace back into position.
Light Bulb Replacement Method 2:
1.Remove the two screws holding the glass retainer and pull forward to remove the glass. Place the glass and re- tainer in a safe spot.
2.Remove the five screws holding the defuser screen. Pull the top two corners in towards the center and remove from the unit.
3.Remove the two screws that hold the flame divider in place and remove.
4.Remove the light bulbs by holding one wire from one side of the socket and slide the light bulb to the opposite side of the wire that you are holding.
5.Repeat steps 4 through 1 to
