5
OPERATION
There are two operation controls for the EF31.
1 - Controls the heater. 2 - Controls the flame effect.
To access the controls,
Control Door slide the control door to the right.
1.Heater
To set the heater at the maximum setting - roll the switch up to the uppermost setting.
To turn the heater off - roll the switch down to the lower most setting.
2.Flame effect
The rocker switch is used to turn the flame effect on and off. Depress the left side of the switch to turn the flame effect on and the right side to turn off.
FLAME EFFECT
The flame generator has a random modulating control which causes the flame effect to speed up and slow down sporadically. This action creates the realistic flame appear- ance and can not be modified.
MAINTENANCE
Bulb Replacement : If the flame appears darker on one side of the fireplace, check the light bulbs to ensure that one has not burned out.
Bulb must be replaced with a MAX 75 watt Quartz 78mm light bulb. See Light Replacement section.
FINISHING
MANTEL |
| FRAMING AND FINISHING |
|
|
|
The minimum distance from the top of the unit that the mantel can be installed is 0", at any depth.
When using paint or lacquer to finish the mantel, such paint or lacquer must be heat resistant to prevent discolouration.
CLEARANCE TO COMBUSTIBLES
| Sides | ......................... 0 inches |
|
|
| ||
| Sides | 0 mm / 0 inches |
|
| Back | 0 inches |
|
| Sides | 0 mm / 0 inches |
|
| Floor | 0 inches |
|
| Floor | 0 mm / 0 inches |
|
| Top | 0 inches |
|
| Top | 0 mm / 0 inches |
|
Nailing
Tab
Installation
Sheet
Metal
Screw
1.Choose fireplace location.
2.Place fireplace in position.
3.Frame in fireplace with header across the top. It is im- portant to allow for the finished facing materials when set- ting the depth of the unit.
4.Remove the two screws from the sides of the fireplace and attach the nailing tabs with the screws.
5.To determine the final location of the nailing tab, you must first determine the thickness of your finishing mate- rial (i.e. sheetrock/drywall) This will determine the dimen- sion from the front edge to the nailing tab. Secure with a sheet metal screw supplied.
6.Attach the nailing tabs to the frame.
