20
LOGO PLACEMENT
Remove the backing from the the logo and position onto the
1.27cm
control door as shown.
1.27cm
LOGO
LOG PLACEMENT
It is not necessary to remove the cast front, however, this will make for a more simple log installation.
In order to assemble the log set, the glass door must be removed, see Cast Front / Glass Door Removal in the FINISHING section of this manual.
FIGURE 33a-d
| 2. Place the hole in the underside of log #2 onto the locating |
LOG LOCATING SCREWS | screw, on the left side of the burner. The fibre burner is formed |
to cradle the centre of the log. |
BRACKET
1.Place the rear log, as shown, onto the rear log support brackets. Ensure the cutout on the left underside of the log, fits over the pilot assembly. Bend the bracket on the left side to help retain the rear log.
3.Place the hole in the underside of log #3 onto the locating screw, on the right side of the burner. The bottom branch of log #3 sits infront of, and against, the right end of log #2.
4.Reinstall the glass door & front.
