Napoleon Grills 308 manual Leak Testing Instructions, Regulator

LEAK TESTING INSTRUCTIONS

DO NOT USE A FLAME TO LEAK TEST.

LEAK TESTING: This must be done before initial use, annually and whenever any gas components are replaced or serviced. No smoking while performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check.

1.Turn all burners controls to off. Turn supply valve on.

2.Brush a half and half solution of liquid soap and water onto all joints and connections of the regulator, hose, manifolds and valves.

3.Bubbles will indicate a gas leak. Either tighten the loose joint or replace the part with one recommended by the dealer.

4.If the leak cannot be stopped, shut off the gas supply, disconnect it and have the barbecue inspected by your gas supplier or dealer. Do not use the appliance until the leak has been corrected.

5.Turn off gas supply.

REGULATOR

The following tables lists input values for the appliance.

308 UNITS	BURNER	ORIFICE SIZE		HEAT INPUT	GAS USAGE (TOTAL)
		I	II	(TOTAL)	PROPANE	BUTANE
	MAIN	60	64	8.8 kW	629 g/h	640 g/h
	BACK	60	64	4.4 kW	315 g/h	320 g/h
	SIDE	60	64	4.5 kW	322 g/h	327 g/h
450 UNITS	BURNER	ORIFICE SIZE		HEAT INPUT	GAS USAGE (TOTAL)
		I	II	(TOTAL)	PROPANE	BUTANE
	MAIN	63	65	12.3 kW	879 g/h	894 g/h
	BACK	58	60	5.6 kW	400 g/h	407 g/h
	SIDE	60	64	4.5 kW	322 g/h	327 g/h

Certified Gases / Pressures - Check rating plate to ensure that it corresponds with following list.

Gas Category	I3B/P(30)	I3+(28-30/37)	I3B/P(50)
Orifice Sizes (see above)	I	I	II
Gases / Pressures	Butane 30mbar	Butane 28-30mbar	Butane 50mbar
	Propane 30mbar	Propane 37mbar	Propane 50mbar
Countries	DK, FI, NL, NO,	BE, ES, FR, GB,	DE, AT
	SE	IE, IT, PT

The regulators for both butane and propane 308 units must have a rating of at least 1000 g/h. The regulators for both butane
and propane 450 units must have a rating of at least 1200 g/h. Do not tamper with or modify regulator. Use only regulators	5
which supply the pressure listed in the table above.