9
MAINTENANCE
1.The appliance should be inspected before initial use and inspected and cleaned at least annually by a qualified field service person.
2.Tampering is DANGEROUS and voids all warranties. Any component that is found to be faulty, must be replaced with an approved component.
3.To obtain proper operation, it is imperative that the burner fl ame characteristics are steady, not lifting or fl oating. Check the burner fl ame patterns with the figure below.
4.Periodically remove the logs and examine the burner. If dirty, clean with a soft brush. Also examine the area around the burner air shutter. Any dirt or foreign material, such as spider webs or nests, in this area should be removed. This will ensure long life and trouble free operation. When the ap- pliance is put back in service, check the burner flame patterns with the figure above. Reinstall the logs as shown in the log placement instructions.
5.Periodically check the hose connecting the LP gas cylinder to ensure it is not damaged in any way.
NOTE: Carbon (soot) may build up on the surface of the logs with heavy use. This is more likely to occur when using LP gas. The soot should be cleaned off the surface of the logs periodically to prevent excessive build up. To clean the logs, be sure the fire is out, the gas supply is turned off and the logs are cool to the touch. The soot can then be brushed off with a dry bristle brush or cloth. Take care while cleaning the logs as they can become damaged if mishandled. Care should be taken to dispose of the soot and cleaning materials properly. Keep away from clothing and outdoor furniture.
During the winter months in cold weather climates, it is recommended to disconnect the Patiofl ame and store it in a cool dry place. Do not store the propane tank inside. For the remainder of the year, protect and cover your Patioflame from rain, freezing rain and snow.
HIGH ELEVATION INSTALLATION
This listed gas appliance is tested and approved for elevations from 0 to 4500 feet in Canada and the U.S.
When installing this appliance at an elevation above 4500 feet (in the U.S.), it may be necessary to decrease the input rating by changing the existing burner orifice to a smaller size. Input should be reduced four percent (4%) for each 1,000 feet beyond the 4,500 feet above sea level, unless the heating value of the gas has been reduced, in which case this general rule will not apply. To identify the proper orifice size, check with the local gas utility.
When installing this unit at an elevation above 4,500 feet (in Canada), check with local authorities.
Consult your local gas utility for assistance in determining the proper orifice for your location.
