LIGHTING INSTRUCTIONS
OPEN LID.
ENSURING BURNER CONTROLS
ARE IN THE OFF POSITION, TURN
ON THE GAS SUPPLY VALVE.
LEFT BURNER CENTER BURNER SIDE BURNER RIGHT BURNER
MAIN BURNER LIGHTING
1.PUSH AND TURN ANY MAIN BURNER KNOB SLOWLY TO
THE ’HI’ POSTION. THISACTION WILL IGNITE THE PILOT FLAME WHICH WILL IN TURN LIGHT THE SELECTED BURNER. IF THE PILOT LIGHTS, CONTINUE TO PUSH DOWN ON THE CONTROL KNOB UNTIL THE BURNER LIGHTS AND THEN RELEASE.
2.IF THE PILOT DOES NOT IGNITE, THEN IMMEDIATELY TURN THE CONTROL KNOB
BACK TO THE ‘OFF POSITION AND REPEAT STEP 1 SEVERAL TIMES.
3.IF THE PILOT AND BURNER WILL NOT IGNITE WITHIN 5 SECONDS,
TURN THE CONTROL KNOB TO THE
‘OFF’ POSITION AND WAIT 5
MINUTES FOR ANY EXCESS GAS TO DISSIPATE. EITHER REPEAT STEPS 1 AND 2 OR LIGHT WITH A MATCH.
SIDE BURNER LIGHTING
1.OPEN SIDE BURNER COVER.
2.PUSH AND TURN THE SIDE BURNER CONTROL
KNOB SLOWLY TO THE
‘HI’ POSITION. THIS ACTION WILL IGNITE THE SIDE BURNER
3.IF THE BURNER DOES NOT IGNITE, THEN IMMEDIATELY TURN THE CONTROL KNOB
BACK TO THE ‘OFF’ POSITION AND REPEAT STEP 2 SEVERAL TIMES.
4.IF THE BURNER WILL NOT IGNITE WITHIN 5 SECONDS, TURN THE CONTROL KNOB TO THE ‘OFF’ POSITION AND WAIT 5 MINUTES
FOR ANY EXCESS GAS TO
DISSIPATE. EITHER REPEAT STEPS 2 AND 3 OR LIGHT WITH A MATCH.
The propane cylinder is equipped with an excess flow device. Unless all burners are turned off prior to turning the cylinder on, only small flames will be achievable.
If lighting the unit with a match, clip the match into the supplied lighting rod. Hold the lit match down through the grill and sear plate while turning the corresponding burner
valve to high.
5
