©NationalInstruments Corporation 5 MID-7604/7602Power Drive
❑One oft he followingshielded cable assemblies, as applicable:
–SH68-C68-S (part number 186381-02)
–SHC68-C68-S (part number 186380-02)
Detailed specifications for the MID-7604/7602 are in the Specifications
section in this guide.
Safety Information
Caution Thefollowing paragraphs contain important safety information you must follow
wheninstalling and operating the device.
Donot operate the device in a manner not specified in the documentation.
Misuseof the device may result in a hazard and may compromise the safety
protectionbuilt into the device. If the device is damaged, turn it off and do
notuse it until service-trained personnel can check its safety. If necessary,
returnthe device to National Instruments for repair.
Keepaway from live circuits. Do not remove equipment covers or shields
unlessyou are trained to do so. If signal wires are connected to the device,
hazardous voltagescan exist even when the equipment is turned off. To
avoida shock hazard, do not perform procedures involving coveror shield
removalunless you are qualified to do so. Disconnect all field power prior
to removingcovers or shields.
Ifthe deviceis rated for use with hazardous voltages (>30 Vrms,42.4V
pk,
or 60 Vdc), it may require a safety earth-ground connection wire. See the
devicespecifications for maximum voltage ratings.
Because of thedanger of introducing additionalh azards,d o notinst all
unauthorized parts or modify the device. Use the deviceonly with the
chassis,modules, accessories, and cables specifiedin the installation
instructions. All coversand filler panels must be installed while operating
the device.
Donot operate the device in an explosive atmosphere or where flammable
gasesor fumes may be present. Operate the device only at or below the
pollution degree stated int he specifications.Polluti on consists of any
foreign matter—solid, liquid, or gas—that may reduce dielectric strength
orsurface resistivity. Pollution degrees are listed below.
•Pollution Degree 1—No pollutionor only dry, nonconductive
pollution occurs. The pollution has no effect.