National Instruments 321372C-01, CAN Hardware - page 19

Chapter 2 Installation and Configuration
Getting Started with CAN for Windows NT 2-4
© National Instruments Corporation
3. Find an unused expansion slot of the appropriate type in your
computer.
4. Remove the corresponding slot cover on the back panel of the
computer.
5. Insert the CAN interface into the slot with the CAN connector(s)
sticking out of the opening on the back panel. It might be a tight fit, but
do not force the interface into place. Figure2-3 shows how to install
the PCI-CAN into a PCI expansion slot.
Figure 2-3. Installing the PCI-CAN
6. Screw the mounting bracket of the CAN interface to the back panel rail
of the computer.
7. Replace the top cover (or the access panel to the expansion slot).
8. Turn on your computer and start Windows NT.
When you have finished installing the hardware, proceed to the Connect the
Cables section, later in this chapter.