©
National Instruments Corporation 4-1 Getting Started with CAN for Windows NT
4
Begin to Use the NI-CAN Software
This chapter helps you get started with the NI-CAN software for
Windows NT.

Using the NI-CAN Software

The functions provided by the NI-CAN software are similar to those
provided by many other device drivers. For exampl e, NI-CAN has open,
close, read, and write functions. NI-CAN provides two different levels of
access to a CAN network: the CAN Network Interface Object and CAN
Objects. Both forms of access support timestamping of incoming data, as
well as various forms of queuing.
The CAN Network Interface Object provides low-level access to a CAN
network. Each CAN Network Interface Object maps to a specific CAN
port, with no limitation on the maximum number of ports or cards you can
use (for example, two PCI-CAN/2 interfaces would provide CAN0 through
CAN3). You can use this object to transmit and receive entire CAN frames.
For example, to transmit a CAN frame, you would specify the outgoing
arbitration ID, frame type (data or remote), data length, and data.
The CAN Objects provide higher level access to a CAN network. Each
CAN Object maps to a specific data item (arbitration ID), and you can use
multiple CAN Objects for a given port. When configuring a CAN Object
for use, you specify the arbitration ID, direction of data transfer, data
length, and how you want the data to be accessed (such as periodically).
Forexample, you could configure a CAN Object to transmit an outgoing
data frame for a specific arbitration ID every 100 ms. After opening this
CAN Object, you use the write function to provide data to transmit, and the
NI-CAN embedded firmware handles all periodic timing.
For detailed information about the NI-CAN software and functions, refer
toth e NI-CAN User Manual for Windows 95 and Windows NT and the
NI-CAN Programmer Reference Manual for Win32.