National Instruments FP-1001, FP-1000 FieldPoint Banks

FieldPoint Banks

Please use one page per FieldPoint bank.

Network module _____________________________________ Firmware revision ____________

Address __________________________________________ Baud rate __________________

Circle the state of the following items when your problem occurs:

LEDs POWER : ON/OFF NETWORK: ON/OFF ACCESS: ON/OFF STATUS: ON/OFF

SnapShot feature Enabled/Disabled

Watchdog timer Enabled/Disabled Timeout value ______ ms

Number of FieldPoint terminal bases ________________________________________________

Number of FieldPoint I/O modules __________________________________________________

Base

#Module Name* POWER

LED READY

LED Module Configuration Information

0FP-1000/FP-1001 ON/OFF ON/OFF

1ON/OFF ON/OFF

2ON/OFF ON/OFF

3ON/OFF ON/OFF

4ON/OFF ON/OFF

5ON/OFF ON/OFF

6ON/OFF ON/OFF

7ON/OFF ON/OFF

8ON/OFF ON/OFF

9ON/OFF ON/OFF

* If a terminal base is present but no module is inserted, write “none.”

Contents

Main Page Important Information Warranty Copyright Trademarks WARNING REGARDING MEDICAL AND CLINICAL USE OF NATIONAL INSTRUMENTS PRODUCTS Page Page Tables National Instruments Corporation ix FieldPoint FP-1 000/FP-1001 U ser Manual About This Manual This manual describes how to install and use the FieldPoint FP-1000 and FP-1001 network modules. How to Use This Manual Set Organization of This Manual Conventions Used in This Manual ! Related Documentation Customer Communication FP-1000 and FP-1001 Network Module Overview FP-1000 Connects to RS-232 FP-1001 Connects to RS-485 Installation and Configuration Installing the Network Module Removing the Network Module Connecting Terminal Bases Connecting the FP-1000 to the Network Connecting the FP-1001 to the Network Connecting to the Serial Ports ! RS-232 Interface Specifications RS-485 Interface Specifications RS-485 Network Termination and Biasing Page Chapter 2 Installation and Configuration National Instruments Corporation 2-9 FieldPoint FP-1 000/FP-1001 U ser Manual Address Baud 12345678 Configuring the Network Module Figure 2-12. Address and Baud Rate Switch Rate Switch Cover (Removed) Setting the Network Address Page Setting the Baud Rate Connecting Power to the FP-1000 or FP-1001 Calculating Power for a FieldPoint Bank Feature Set Description High-Speed Local Bus Network Watchdog Timer SnapShot Feature Programmable Power-Up State HotPnP (Hot Plug and Play) HotPnP During Power-Up HotPnP During Operation Inserting New I/O Modules Replacing I/O Modules Page Power-On Self Test (POST) LED Indicators Page Using the FieldPoint Software FieldPoint Software Overview Using the FieldPoint Explorer Using the FieldPoint Server with BridgeVIEW Using the FieldPoint Server with LabVIEW Using the FieldPoint Server with LabWindows/CVI Using the FieldPoint Lookout Driver Using FieldPoint with Optomux Servers Appendix A Specifications Network Page Appendix B FTP Support Customer Communication Electronic Services Bulletin Board Support Telephone and Fax Support Telephone Fax Fax-on-Demand Support E-Mail Support (currently U.S. only ) FieldPoint System Configuration Form Host Computer FieldPoint Software FieldPoint Banks Technical Support Form Documentation Comment Form Title: Edition Date: Part Number: Mail to: Technical Publications Fax to: Technical Publications Glossary Page Index A B C D E F H I L M N O P