Index
© National Instruments Corporation I-3 FieldPoint FP -1000/FP- 1001 User Manual
L
LabVIEW software, using with FieldPoint
Server, 4-3
LabWindows/CVI software, using with
FieldPoint Server, 4-3
LED indicators, 3-7 to 3-8
local bus, high-speed, 3-1
M
manual. See documentation.
N
network address, setting, 2-10 to 2-11
NETWORK LED, 3-7
network module. See FieldPoint network
modules.
network termination and biasing, RS-485
ports, 2-7 to 2-9
network watchdog timer, 3-1 to 3-2
O
Optomux protocol, 1-1
Optomux Servers, using with FieldPoint
software, 4-4
P
pinouts. See connector pinouts.
power connections, 2-12 to 2-13
calculating power for FieldPoint
bank,2-13
pinout (figure), 2-13
POWER LED, 3-7
power-on self test (POST), 3-6 to 3-7
Programmable Power-Up State, 3-3 to 3-4
R
removing FieldPoint network module, 2-2
RS-232 ports
connector pinout (figure), 2-6
FP-1000 connection to, 1-1
interface specifications, 2-6 to 2-7
self-configuration parameters, 2-6
RS-485 ports
Combicon adapter for termination
(figure), 2-8
connector pinout (figure), 2-7
FP-1001 connection to, 1-2
interface specifications, 2-7 to 2-9
isolation from FieldPoint system
(note),2-5
network termination and biasing,
2-7to 2-9
self-configuration parameters, 2-6
typical signal connections (figures),
2-8to 2-9
S
serial ports. See RS-232 ports; RS-485 ports.
SnapShot feature, 3-2 to 3-3
software. See FieldPoint software.
specifications, A-1 to A-2
compliance, A-2
environment, A-2
network, A-1 to A-2
STATUS LED, 3-8
switches
address and baud rate switch (figure), 2-9
baud rate switch settings (figure), 2-12
network address switch settings
(figure),2-11