FP-CTR-502 and cFP-CTR-502 2 ni.com
Installing the FP-CTR-502The FP-CTR-502 mounts on a FieldPoint terminal base (FP-TB-x),
which provides operating power to the module. Installing the
FP-CTR-502 onto a powered terminal base does not disrupt the
operation of the FieldPoint bank.
To install the FP-CTR-502, refer to Figure1 and complete the
following steps:
1. Slide the terminal base key to either position X, used for any
module, or position8, used for the FP-CTR-502 module.
2. Align the FP-CTR-502 alignment slots with the guide rails on
the terminal base.
3. Press firmly to seat the FP-CTR-502 on the terminal base.
When the module is firmly seated, the terminal base latch locks
it into place.
Figure 1. Installing the FP-CTR-502
Installing the cFP-CTR-502The cFP-CTR-502 mounts on a Compact FieldPoint backplane
(cFP-BP-x), which provides operating power to the module.
Installing the cFP-CTR-502 onto a powered backplane does not
disrupt the operation of the FieldPoint bank.
To install the cFP-CTR-502, refer to Figure2 and complete the
following steps:
1. Align the captive screws on the cFP-CTR-502 with the holes
on the backplane. The alignment keys on the cFP-CTR-502
prevent backward insertion.
Alignment
Slot
Key
Latch
Guide Rails
Terminal BaseI/O Module