Chapter 4 Common Configuration Questions
© National Instruments Corporation 4-3 NI PXI-8108 User Manual
What if I don’t have a Y-splitter cable? Can I still use a mouse and
keyboard?
If you do not have a Y-splitter cable, plug a USB keyboard into any
USB connector. You can also plug a USB mouse into any USB connector.
How do I connect a standard 25-pin LPT cable to the
NI PXI-8108?
The NI PXI-8108 uses a type C LPT connector. Most parallel port
devices use a type A connector. To use a device with a standard type A
LPT connector, you need to use a type C-to-type-A LPT adapter. Parallel
port adapter cables, part number 777169-01, are available through the
online catalog at ni.com/products.
How do I connect a VGA monitor to the NI PXI-8108?
A VGA-to-DVI-I adapter (part number 762559-01) is included with your
kit. You can use this adapter to connect a VGA monitor to the DVI-I port.
Software Driver Installation
How do I install or reinstall the video driver?
Refer to KnowledgeBase 3H3COSD8 at ni.com support.
How do I install or reinstall the Ethernet driver?
Refer to KnowledgeBase 3H3COSD8 at ni.com support.
How do I install or reinstall the GPIB driver?
The NI-488.2 driver for your GPIB port is installed by default when your
controller is first shipped from the factory. To change the default installed
driver, complete the following steps:
1. Download the latest GPIB driver from ni.com/downloads.
2. Install the driver and verify that the driver has properly detected the
GPIB driver in the Device Manager. If you need more assistance, refer
to ni.com/support/install.