National Instruments NI PXI PCI-1411 Signal Connections

Signal Connections

This chapter describes cable connections for the NI 1411.

I/O Connector

The NI 1411 uses one S-Video and two BNC connectors on the front panel

to connect to video data inputs and the external trigger signal. Figure 3-1

shows the position of the three connectors.

Figure 3-1. NI 1411 Connectors

S-VIDEO

TRIG

VIDEO

Contents

Main Page Important Information Warranty Copyright Trademarks Patents Compliance Compliance with FCC/Canada Radio Frequency Interference Regulations Determining FCC Class FCC/DOC Warnings Class A Conventions Contents Page Introduction About the NI 1411 Using PXI with CompactPCI Software Overview NI-IMAQ Driver Software National Instruments Application Software Vision Builder for Automated Inspection Vision Development Module Integration with DAQ and Motion Control Hardware Overview Functional Overview Video Acquisition Video Decoder Color-Space Processor and LUTs SDRAM Trigger Control and Mapping Circuitry Acquisition, Scaling, ROI Scatter-Gather DMA Controllers Bus Master PCI Interface Board Configuration NVRAM Start Conditions Acquisition Window Control Page Signal Connections I/O Connector Signal Description Custom Cables A Introduction to Color Image Representations RGB Color Planes Hue, Saturation, Luminance, and Intensity Planes 32-Bit HSL and HSI B Technical Support and Professional Services Page Glossary Symbols A B C D E F G H I K L M N O P R S T V Index A B C D I K L M N S T V W