© National Instruments Corporation 17 NI sbRIO-960x
Using the Reset Button
Pressing the Reset button reboots the processor. The FPGA continues to
run unless you select the Autoload VI on Device Reboot boot option.
Refer to the Boot Options section for more information.
Understanding LED Indications
Figure 11. sbRIO-960x LEDs

FPGA LED

You can use the FPGA LED to help debug your application or easily
retrieve application status. Use the LabVIEW FPGA Module and NI-RIO
software to define the FPGA LED to meet the needs of your application.
Refer to LabVIEW Help for information about programming this LED.

USER LED

You can define the USER LED to meet the needs of your application. To
define the LED, use the RT LEDs VI in LabVIEW. For more information
about the RT LEDs VI, refer to the LabVIEW Help.

POWER LED

The POWER LED is lit while the sbRIO device is powered on. This LED
indicates that the 5 V and 3.3 V rails are stable.

STATUS LED

The STATUS LED is off during normal operation. The sbRIO device
indicates specific error conditions by flashing the STATUS LED a certain
number of times as shown in Table 4.
1FPGA
2USER
3POWER
4STATUS
3
1
4
2