National Instruments NI sbRIO-960x

You can install up to three board-only C Series I/O modules on the

sbRIO-960x. The following figure shows the dimensions of the

sb-RIO-960x with three board-only C Series I/O modules installed.

Figure 3. sbRIO-960x with C Series Modules, Dimensions in Inches (Millimeters)

Note To maintain isolation clearances on the C Series modules, do not use mounting

hardware larger than 0.240 in. (6.1 mm) in diameter and maintain an air gap of at least

0.200 in. (5.0 mm) from the modules to anything else.

1.212 (30.78)

.000 (0)

.285 (7.23)

6.565 (166.75)

2.885 (73.28)

2.514 (63.86)

3.965 (100.71)

3.650 (92.71)

.000 (0)

8.200 (208.28)

2.889 (73.38)

2.910 (73.91)

5.799 (147.29)

5.820 (147.83)

8.709 (221.21)

6.442 (163.63)

3.340 (84.84)

Ø.512 (13)

8X Ø .125 (3.18)

4.265 (108.33)

5.515 (140.08)

Contents

Main USER GUIDE NI sbRIO-960x Single-Board RIO OEM Devices What You Need to Get Started Software Requirements Hardware Requirements Page NI sbRIO-960x 4 ni.com The following figure shows the dimensions of the sbRIO-960x. Figure 2. sbRIO-960x Dimensions in Inches (Millimeters) Page I/O and Other Connectors on the sbRIO Device The following figure shows the locations of parts on the sbRIO device. Figure 4. sbRIO-960x Parts Locator Diagram Page The following figures show the pinouts of the I/O connectors on the sbRIO devices. Figure 5. Pinout of I/O Connector P2, 3.3 V Digital I/O Figure 6. Pinout of I/O Connector P3, 3.3 V Digital I/O Figure 7. Pinout of I/O Connector P4, 3.3 V Digital I/O Figure 8. Pinout of I/O Connector P5, 3.3 V Digital I/O The following figure and table show the signals on J1, the RS-232 serial port. Figure 9. J1, RS-232 Serial Port Connecting the sbRIO Device to a Network Powering the sbRIO Device Powering On the sbRIO Device Boot Options Connecting Serial Devices to the sbRIO Device Using the Internal Real-Time Clock Configuring DIP Switches SAFE MODE Switch CONSOLE OUT Switch IP RESET Switch NO APP Switch USER1 Switch NO FPGA Switch Using the Reset Button Understanding LED Indications FPGA LED USER LED POWER LED Resetting the Network Configuration of the sbRIO Device Integrated 3.3 V Digital I/O I/O Protection Drive Strength Signal Integrity Using +5 V Power from 3.3 V DIO Headers P2P5 Specifications Network Processor Speed Memory Xilinx Spartan 3 Reconfigurable FPGA 3.3 V Digital I/O Resistance-temperature characteristics, typical curve Power Requirements Working I/O Voltages Environmental Management Waste Electrical and Electronic Equipment (WEEE) Environmental RoHS Cabling Where to Go for Support