Appendix E SCXI-1163 Cabling
© National Instruments Corporation E-9 SCXI-1163 User Manual
Table E-4. SCXI-1163 and DIO-96, AT-MIO-16D, and AT-MIO-64F-5 Board
Pinout Equivalences (Continued)
Pin SCXI-1163 Rear Signal
Connector DIO-96
Board
Equivalent
AT-MIO-16D
Board
Equivalent
AT-MIO-64F-5
Board
Equivalent
Serial Parallel
67 In (15) CPB7 PB7
69 In (14) CPB6 PB6
71 In (13) CPB5 PB5
73 In (12) CPB4 PB4
75 In (11) CPB3 PB3
77 In (10) CPB2 PB2
79 In (9) CPB1 PB1
81 In (8) CPB0 PB0
83 In (7) CPA7 PA7
84 In (31) DPA7
85 In (6) CPA6 PA6
86 In (30) DPA6
87 In (5) CPA5 PA5
88 In (29) DPA5
89 In (4) CPA4 PA4
90 In (28) DPA4
91 In (3) CPA3 PA3
92 In (27) DPA3
93 In (2) CPA2 PA2
94 In (26) DPA2
95 In (1) CPA1 PA1
96 In (25) DPA1
97 In (0) CPA0 PA0
98 In (24) DPA0
100 DIG GND GND DIG GND GND
All other pins are not connected on the SCXI-1163.
SCXI-1351 and NB5 Cable Installation
Follow these steps to install the SCXI-1351:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module in the chassis.
3. Connect the positions 1 through 50 connector (or 51 through 100, as appropriate) of the NB5
cable to the male breakout connector on the SCXI-1351.
4. Plug the mounting bracket connector onto the module rear signal connector (see Figure E-2).
An alignment tab on the bracket will enter the upper board guide of the chassis.
5. Screw the mounting bracket to the threaded strips in the rear of the chassis.
6. Connect the 100-pin connector of the NB5 cable to the board.