NEC L227HR user manual Quick Start, English-6

Quick Start

To attach the Base to the LCD stand:

1. Place monitor face down on a non-abrasive surface (Figure 1).

NOTE: Handle with care when monitor facing down, for avoiding damage to the front control buttons.

2. Please pivot base 90 degrees as shown in Figure 1.

NOTE: Handle with care when pulling the stand.

3. Attach the base stand to LCD monitor and lock screws of base stand bottom (Figure 2).	Control
	buttons
Figure 1
NOTE: Reverse this procedure if you need to re-pack the monitor.

Screws

To attach the MultiSync LCD monitor to your system, follow these instructions:

1. Turn off the power to your computer.

2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the

connector of the display card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the
connector of the display card in your system (Figure A.2). Tighten all screws.
For the MAC: Connect the Macintosh cable adapter to the computer, then attach the
15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure A.3).	Figure 2
Tighten all screws.

DVI signal cable

Figure A.1 Figure A.2

Macintosh

Cable Adapter Figure A.3 (not included)

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

3.Place hands on each side of the monitor to tilt the LCD panel 15-degree angle and lift up to the highest position (FigureB.1).

4.Connect all cables to the appropriate connector on the back of the monitor (Figure B.1).

5.Position the Video Signal Cable and power cord between the holes on the Stand, as indicated in Figure B.2/Figure B.3.

15û Tilt

Highest stand position

Power Cord Input (DVI)

Input (D-SUB)

Figure B.1 Figure B.2 Figure B.3

English-6