NEC LCD1525V user manual Quick Start, Figure A.1

Quick Start

To attach the MultiSync® LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable

to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync LCD1525V™ Macintosh cable adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB end of the appropriate signal cable to the MultiSync LCD1525V Macintosh cable adapter (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync LCD1525V Macintosh cable adapter, call NEC Technologies at (800) 820-1230.

Remove connector cover and cable cover on back of monitor.

3.Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on the back of the monitor (Figure C1).

Place the Video Signal Cable under Clip A. Then place AC Adapter Cable under Clip B. Replace connector cover and cable cover.

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the module’s life.

4.Connect one end of the power cord to the MultiSync LCD Series monitor and the other end to the power outlet (Figure D.1).

5.Turn on the monitor (Figure E.1) and the computer.

6.To complete the setup of your MultiSync LCD monitor, use the following OSM™ controls:

•Auto Adjust Contrast

•Auto Adjust

Refer to the Controls section of this User’s Manual for a full description of these OSM controls.

NOTE: For download information on the Windows 95/98 INF file for your MultiSync LCD1525V monitor, refer to the References section of this User’s Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

	15-pin
	mini D-SUB
	15-pin
	mini
	D-SUB
	Mac Adapter
	(not included)
Figure A.1	Figure B.1
	3

78134641.wpc 5 5/4/99, 5:37 PM