NEC LCD1550V user manual Quick Start, English-6

Quick Start

To attach the MultiSync LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.Remove connector cover and cable cover.

3.For PC: Connect the 15-pin mini D-SUB of the appropriate signal cable to the connector for the display card in your system (Figure A.1). Tighten all screws.

For Mac: Connect the MultiSync LCD1550V Macintosh cable adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB end of the appropriate signal cable to the MultiSync LCD1550V Macintosh cable adapter (Figure B.1). Tighten all screws.

4.Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on the back of the monitor (Figure C.1). Place the Video Signal Cable under Clip B.

5.Connect one end of the power cord to the MultiSync LCD Series monitor and the other end to the power outlet. Place the video signal cable and AC power cord under the clips (Figure C.1). Replace connector cover and cable cover.

NOTE: Adjust the position of the cable under the clips to avoid damage for cable or monitor.

NOTE: Please refer to Caution section of this manual for proper selection of AC power cord.

6.The Vacation Switch on the right side of the monitor must be turned on (Figure D.1). Turn on the monitor with the Power Button and the computer.

NOTE: The Vacation Switch is a true on/off switch. If this switch is on the OFF position, the monitor cannot be turned on using the front button DO NOT switch on/off repeatedly.

7.No-touch auto adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For further adjustments, use the following OSM controls:

•Auto Adjust Contrast

•Auto Adjust

English-6