NEC LCD1550X manual Quick Start, Turn off the power to your computer

Quick Start

To attach the MultiSync® LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI-A signal cable to the connector of the display card in your system (Figure A.2).

For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

NOTE: To obtain the MultiSync Macintosh cable adapter call NEC-Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.

3.Remove connector cover. Connect the DVI signal cable to the connector on the back of the monitor. Place the video signal cable (Figure C.1). Replace the connector cover.

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/ components of LCD module and/or shorten the module’s life.

4.Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet (Figure C.1).

NOTE: If you use this monitor at AC220-240V, please refer to Recommended Use section of this manual for proper selection of AC power cord.

5.The Vacation Switch on the right side of the monitor must be turned on. Turn on the monitor with the front power button (Figure D.1) and the computer.

NOTE: The Vacation Switch is a true on/off switch. If this switch is on the OFF position, the monitor cannot be turned on using the front button. DO NOT switch on/off repeatedly.

6.No-touch auto adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For further adjustments, use the following OSM™ controls:

•Auto Adjust Contrast

•Auto Adjust

Refer to the Controls section of this User ’s Manual for a full description of these OSM controls.

NOTE: For download information on the Windows® 95/98/2000/XP INF file for your MultiSync LCD1550X monitor, refer to the References section of this User’s Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

NOTE: Refer to User ’s Manual in the NEC LCD Setup Software CD case for installation and operation of this software.-

Figure A.1	Figure A.2
	3

LCD1550X.P65 3 10/10/01, 3:24 PM