NEC LCD1550X manual Tilt and Swivel, Remove Monitor Stand for Mounting

Quick Start –continued

Tilt and Swivel

Grasp both sides of the monitor screen with your hands and adjust the tilt and swivel as desired (Figure TS.1).

Remove Monitor Stand for

Mounting

To prepare the monitor for alternate mounting purposes:

1. Disconnect all cables. Figure TS.1

2.Place hands on each side of

the monitor and lift up to the highest position (Figure RL.1).

3.Place monitor face down on a non-abrasive surface. (Place the screen on a 2-inch platform so that the stand is parallel with the surface.)

(Figure S.1)

Figure S.1

4.Remove the stand cover by sliding the top/bottom pieces off the stand (Figure S.2). Remove the 4 screws connecting the monitor to the stand and lift off the stand assembly (Figure S.3). The monitor is now ready for mounting in an alternate manner.

5.Reverse this process to reattach stand.

NOTE: Use only VESA-compatible alternative mounting method.

Figure S.2 and Figure S.3

Caution: Please use the attached screws (4 pcs) when mounting. To fulfil the safety requirements the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor shall only be used with an approved arm (e.g. GS mark).

6

LCD1550X.P65 6 10/10/01, 3:24 PM