NEC LCD1850E user manual Quick Start, English-6

Quick Start

To attach the MultiSync LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.1).

For the Mac: Connect the MultiSync Macintosh cable adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

3.Remove connector cover. Connect the 15-pin mini D-SUB signal cable to the connector on the back of the monitor. Place the video signal cable (Figure C.1).

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the moduleÕs life.

4.Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet (Figure C.1). Replace the connector cover.

NOTE: Please refer to Caution section of this manual for proper selection of AC power cord.

5.Check the Vacation Switch on the right hand side of the monitor is in the ON position. Turn on the monitor with the Power Button (Figure D.1) and the computer.

NOTE: There are two switches: one on the right side and one on the front side of the monitor. DO NOT switch on/off quickly.

6.To complete the setup of your MultiSync LCD monitor, use the following OSM controls:

¥Auto Adjust Contrast

¥Auto Adjust

Refer to the Controls section of this UserÕs Manual for a full description of these OSM controls.

English-6