NEC LCD1970NX, LCD1970VX Quick Start, Figure A.1, Figure A.2, Figure C.1, Figure C.2, English-4

Quick Start

To attach the MultiSync LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws.

For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure B.1). Tighten all screws.

DVI signal cable	Figure A.1	Figure A.2
(not included)

Macintosh

Cable Adapter Figure B.1 (not included)

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

3.Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position (Figure C.1).

4.Connect all cables to the appropriate connectors (Figure C.1).

5.Place power cord into the specific hooks indicated in Figure C.2.

6.Place the D-Sub into the specific hooks indicated in Figure C.2.

30˚ Tilt

Highest

Stand

Position

Power Cord

D-SUB Cable

DVI Cable (not included)

Figure C.1 Figure C.2

DC-OUT (NX/NXp only)

NEC optional product attachment.

Do not use this connector unless specified.

English-4