NEC LCD2180 Tilt, Remove Monitor Stand for Mounting, Figure TS.1, Figure S.1, Figure S.2, English

Tilt

Grasp top and bottom sides of the monitor screen with your hands and adjust the tilt as desired (Figure TS.1).

Figure TS.1

NOTE: Handle with care when tilting the monitor screen.

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:

1.Disconnect all cables.

2.Place monitor face down on a non-abrasive surface (Figure S.1).

Figure S.1

3.Remove the four screws connecting the monitor to the stand using the Hexagon Socket Screw keys (Figure S.2). Lift the stand of the monitor. The monitor is now ready for mounting in an alternate manner.

4.Reverse this process to reattach stand: tighten the four screws.

NOTE: Use only VESA-compatible alternative mounting method (100 mm pitch).

NOTE: Handle with care when removing monitor stand.

English

Figure S.2

NOTE: When using the original stand, be sure the two round indents are at the bottom of the screen (Figure S.3).

Caution: Use the original screws (4 pcs) when mounting to avoid damage to the monitor and stand. To fulfil the safety requirements the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. GS mark).

Figure S.3

Caution: This monitor does not support the portrait mode. The brightness become dark when using portrait mode to avoid damage when internal display temperature exceed the limited temperature.

English-5