Quick Start
To attach the Base to the LCD Stand:
1.Insert the front of the LCD Stand into the holes in the front of the Base (Figure 1).
2.Next, position the locking tabs on the back side of the LCD Stand with the holes on the Base. Lower the Stand until locking tabs are secure.
Figure 1
Stand |
|
Locking Tabs | Front Base |
To attach the AccuSyncLCD monitor to your system, follow these instructions:
1.Turn off the power toyour computer.
2.For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the
For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the
NOTE: To obtain the AccuSync Macintosh cable adapter, call NEC Display Solutions of America, Inc. at (800)
3.Connect
4.Connect one end of the power cord to the LCD and the other end to the power outlet. Place the video signal cable, power cord, DVI cable, and audio cable into the cable holder between each hole of the stand neck. Insert the tabs of the cable holder until it clicks. (Figure B.1)
NOTE: Adjust the position of cables in the holder to avoid damage.
NOTE: Refer to Recommended Use section of this manual for proper selection of power cord.
5.Turn on the monitor with the front power button and then turn on computer. (Figure C.1)
6.Select input source by Source button or Input Select on OSD menu.
7.
•Image Setup
Refer to the Controls section of this User’s Manual for a full description of these OSD controls.
NOTE: For download information on the Windows® INF file for your NEC monitor, visit www.necdisplay.com.
NOTE: If you have any problems, please refer to the Troubleshooting section of this NEC User’s Manual.
5