If you want to use your remote control with the cable, connect one end of the cable to the jack on the remote control and the other end to the Terminal Panel.

1.Mouse Button￿ Works as a mouse for your projected computer image. This button is also used to adjust position, zoom and focus.

2.Position Button￿ When you’re in the 2X or 4X mode, hold this button down and adjust the picture position up and down or left and right with the mouse pad.

3.Zoom Button￿ Hold this button down and adjust the picture size (zoom in or out) with the mouse pad.

4.Focus Button￿ Hold this button down and adjust the focus with the mouse pad.

5.2X/4X Button￿ Pressing this button will enable you to toggle between a standard image, a double-sized (2X) image and a quadrupled image (4X).

6.RGB Button￿ Press to select an RGB video source from a computer or document camera.

7.S-Video Button￿ Press to select an S-Video source from a VCR.

8.Video Button￿ Press to select an NTSC, PAL, SECAM or M-NTSC compatible video source from a VCR or laser disc player.

9.Freeze Button￿ This button will freeze a picture.

10.Menu Button￿Use this button to call up the menu of icons to adjust and set the image.

11.Select Button￿Make your on-screen menu selections for adjusting and setting the image with this button. (See page 35.)

3.Remove the two screws securing the lamp case. (There is an interlock on this case to prevent the risk of electrical shock. Do not attempt to circumvent this interlock.)

4.Use the lamp case handle to remove the assembly.

5.Install a new lamp case assembly and secure it in place with the two screws.

CAUTION: Do not use lamps other than the NEC optional lamp. Order by your projection's model number.

6.Reattach the lamp cover and reinstall the single screw.

7.After you install a new lamp, select the Lamp Usage icon and press and hold the “Power On” button on the remote control for ten seconds to reset the lamp time clock to zero.

NOTE: When you replace the lamp, it is also wise to replace the filter. The filter comes in the same package with your replacement lamp. Contact your NEC dealer for replacement lamps. Order by your projector’s model number.

CAUTION: Do not put the LCD projector on end except for lamp and/ or air filter replacement.

Remote Jack

Insert the supplied remote cable here.

Left click button*

21

Step 4

Step 5

Step 6

MAINTENANCE

 

42