BMenu Button

Use this button to call up the On-Screen Menu so you can adjust and set the image. After you press this button, it will light up. During this time you can use the mouse pointer and right/left click buttons to make menu selections. If no buttons are pressed within 10 seconds while it illuminates, the light goes out. To return to the main menu from a sub menu, press this button again.

CMouse Pointer Button

Works as a mouse for your projected computer image. This button is also used to adjust position.

This button selects the submenu you want to adjust. (See page 49.)

After you make your on-screen menu selection, use this button to adjust the B level up or down. (See page 49.)

DRight Click Button

Press this button to exit "Menus" or "Position."

EFreeze Button

This button will freeze a picture. Press again to resume motion.

F Position Button

D

When the picture is magnified, press this button to activate the mouse

buttons that you can use to reposition the image in eight directions. When

 

you're finished, the "Position" button will remain lit for 10 seconds.

F

NOTE: When you are adjusting Position, the Mouse Pointer button is used to move the picture.

27

OFF POWER ON

VIDEO S-VIDEO VOLUME

+

RGB 1 RGB 2

–

MENULASER

C

–+

R-CLICK

POSITION PIC-MUTE FREEZE

E

MAGNIFYG

REDUCE ZOOM FOCUS

+ + +

HI

GPicture Mute Button

This button turns off the image for a short period of time. Press again to restore the image.

HMagnify/Reduce Button

Use the (+) or (–) button to adjust the image size up to 400%.

IFocus Button

Press the (+) or (–) button to adjust the focus.

JZoom Button

Press the (+) button to zoom in and the (–) button to zoom out.

KRemote Jack

Connect your remote control cable here for for wired operation.

NOTE: You cannot use Menu and Position at the same time.

Remote Control Precautions

•Do not look into the laser pointer while it is on.

•Do not point the laser beam at a person.

•When the cable is connected to the remote control, it will not work in the wireless mode.

•Handle the remote control carefully.

•If the remote control gets wet, wipe it dry immediately.

•Avoid excessive heat and humidity.

•If you will not be using the remote control for a long time, remove the batteries.

•Do not mix new and old or different types of batteries.

– – –

J

K

INTRODUCTION

 

28