Data Programming Procedure, Step Work Remarks

4.DATA PROGRAMMING PROCEDURE

Table 1-1shows the procedure and the outline of the work related data programming for the system.

The various data programmed in this manual are entered into the system through the CAT/MAT.

Table 1-1 Data Programming Procedure

STEP	WORK	REMARKS

1.	Obtain the customer’s requirements, and fill in the
	Customer Specification Sheets on Chapter 2.

2.	Allocate the LC, TRUNK and other interface cards to
	the Port Assignment Table on Chapter 2. Make a Bay
	Face Layout on Chapter 2 for accommodating cards
	required in the system.

3.	Fill in the data programming sheets on Chapter 3 with	For the programming method and the detailed
	the Customer Specification Sheet, Port Assignment	information on the Command, refer to the Command
	Table and Bay Face Layout completed as steps 1 and	Manual.
	2.

4.	Ensure that the data on all programming sheets are
	correct and consistent with customer specifications.

5.	Specify the switch setting on the boards with the	For the function of each switch on the cards, refer to
	Switch Setting Table in the Circuit Card Manual.	the Circuit Card Manual.

ND-45503 (E)CHAPTER 1

Page 3

Revision 2.0