CHAPTER 3 DATA PROGRAMMING SHEETS

1.GENERAL

This chapter provides the System Data Sheets for programming the Customer Specifications in Chapter 2. For the programming method and the detailed information on the commands, refer to the Command Manual.

In the Programming sheets, the meanings of markings are as follows:

: Initial Data

With the system data clear command (CM00, CM01), the data with this marking is automatically as- signed for each command.

In the programming sheets, initial data, which are automatically loaded into the memory after system initializa- tion, are indicated with “ .” Therefore, the installer should confirm the meaning of initial data, and change or delete the data, if required.

INITIAL

MAT

:System Initialization

After entering the data, a system reset is required (Depress SW1 of the MP card).

:MAT Mode

If there is a MAT abbreviation under the command code designation, then programming can be accomplished by the MAT mode of programming instead of the MOC mode or CAT mode.

ND-45503 (E)CHAPTER 3

Page 25

Revision 2.0

Page 34
Image 34
NEC NEAX 2000 IVS manual Data Programming Sheets