3. Projecting an Image (Basic Operation)

Adjust the Tilt Foot

1. Lift the front edge of the projector.

CAUTION:

Do not try to touch the ventilation outlet during Tilt Foot adjustment as it can become heated while the projector is turned on and after it is turned off.

2.Push up and hold the Adjustable Tilt Foot Lever on the front of the projector to extend the adjustable tilt foot.

3.Lower the front of the projector to the desired height.

4.Release the Adjustable Tilt Foot Lever to lock the Adjustable tilt foot.

The tilt foot can be extended up to 1.6 inch/40 mm.

There is approximately 10 degrees (up) of adjustment for the front of the projector.

Rotate the rear foot to the desired height in order to square the image on the projection surface.

CAUTION:

Do not use the tilt-foot for purposes other than originally intended.

Misuses such as using the tilt foot to carry or hang (from the wall or ceiling) the projector can cause damage to the projector.

1

Ventilation outlet

2

Adjustable Tilt Foot

 

Adjustable Tilt

Foot Lever

3

4

Adjusting the left and right tilt of an image [Rear foot]

1.Remove the spacer (black rubber) from the rear foot. Keep the spacer for future use.

2.Rotate the rear foot.

The rear foot can be extended up to 0.4 inch/10 mm. Rotating the rear foot allows the projector to be placed horizontally.

NOTE: After using the projector, attach the spacer to the rear foot.

Rear foot

Spacer (black rubber)

Up Down

22