5. Using On-Screen Menu

Turning On the Projector By Applying Computer Signal [AUTO POWER ON(COMP.)/[AUTO POWER ON(COMP1) ] for NP216]

When the projector is in Standby mode, applying a computer signal from a computer connected to the COMPUTER IN input (COMPUTER 1 IN on NP216) will power on the projector and simultaneously project the computer’s image. This functionality eliminates the need to always use the POWER button on the remote control or the projector cabinet to power on the projector.

NOTE:

•Disconnecting a computer signal from the computer will not power off the projector. We recommend using this function in com- bination of the AUTO POWER OFF function.

•This function will not be available under the following conditions:

-when a component signal is applied to the COMPUTER IN (COMPUTER 1 IN on NP216) connector

-when a Sync on Green RGB signal or composite sync signal is applied

•To enable the AUTO POWER ON (COMP.)/AUTO POWER ON (COMP1) after turning off the projector, wait 3 seconds and input a computer signal.

If a computer signal is still present when the projector is turned off, the AUTO POWER ON (COMP.)/AUTO POWER ON (COMP1) will not work and the projector remains in standby mode.

Enabling Power Management [AUTO POWER OFF]

When this option is selected you can enable the projector to automatically turn off (at the selected time: 5min., 10min., 20min., 30min.) if there is no signal received by any input or if no operation is performed.

Selecting Default Source [DEFAULT SOURCE SELECT]

You can set the projector to default to any one of its inputs each time the projector is turned on.

LAST����������������������������������對Sets the projector to default to the previous or last active input each time the projector is turned on.

AUTO ����������������������������������Searches for an active source in order of COMPUTER → VIDEO → S-VIDEO → COMPUTER (COM- PUTER 1 → COMPUTER 2 on NP216) and displays the first found source.

COMPUTER ������������������������Displays the computer signal from the COMPUTER IN connector every time the projector is turned on.

COMPUTER 1

(NP216 only) ����������������������Displays the computer signal from the COMPUTER 1 IN connector every time the projector is turned on.

COMPUTER 2

(NP216 only) ����������������������Displays the computer signal from the COMPUTER 2 IN connector every time the projector is turned on.

VIDEO ���������������������������������Displays the Video source from the VIDEO IN connector every time the projector is turned on. S-VIDEO �����������������������������Displays the Video source from the S-VIDEO IN connector every time the projector is turned on.

Selecting Port for External Equipment [CONTROL TERMINAL] (NP216/NP215 only)

This option allows you to select a port for controlling the projector either from PC Control or over a LAN.

PC CONTROL��������� Select for controlling the projector from external equipment connected to the PC CONTROL port (D-Sub 9 Pin).

LAN������������������������ Select for controlling the projector from external equipment connected to the LAN port (RJ-45).

NOTE:

-When [POWER-SAVING] is selected for [STANDBY MODE], controlling the projector from external equipment is not possible.

-The PC Control port and LAN port are not active at the same time.

64