CHAPTER 5 CLOCK GENERATOR
User’s Manual U15331EJ4V1UD 105
5.5 Clock Generator Operation
The clock generator generates the following clocks and controls the operation modes of the CPU, such as the
standby mode.
• Main system clock fX
• Subsystem clock fXT
• CPU clock fCPU
• Clock to peripheral hardware
The operation and function of the clock generator is determined by the processor clock control register (PCC),
subclock oscillation mode register (SCKM), and subclock control register (CSS), as follows.
(a) T he low-speed mode (1.6
µ
s: at 5.0 MHz operation) of the main system clock is selected when the
RESET signal is generated (PCC = 02H). While a low level is being to the RESET pin, oscillation of the
main system clock is stopped.
(b) Three types of minimum instruction execution time (0.4
µ
s and 1.6
µ
s: main system clock (at 5.0 MHz
operation), 122
µ
s: subsystem clock (at 32.768 kHz operation)) can be selected by the PCC, SCKM,
and CSS settings. Also, the subsystem clock can be changed to a clock that uses a circuit to multiply
the subclock by 4 via a mask option in the
µ
PD789488 and 789489 or the subclock selection register
(SSCK) in the
µ
PD78F9488 and 78F9489 (15.26
µ
s: a circuit to multiply the subsystem clock by 4 is
used).
(c) Two standby modes, STOP and HALT, can be used with the main system clock selected. In a system
where the subsystem clock is not used, setting bit 1 (FRC) of SCKM so that the on-chip feedback
resistor cannot be used reduces current consumption in STOP mode. In a system where the
subsystem clock is used, setting SCKM bit 0 to 1 can cause the subsystem clock to stop oscillation.
(d) CSS bit 4 (CSS0) can be used to select the subsystem clock so that low current consumption operation
is used (122
µ
s: at 32.768 kHz operation).
(e) With the subsystem clock selected, it is possible to cause the main system clock to stop oscillating
using bit 7 (MCC) of PCC. The HALT mode can be used, but the STOP mode cannot.
(f) The clock pulse for the peripheral hardware is generated by dividing the frequency of the main system
clock, but the subsystem clock pulse is only supplied to 8-bit timer 50, the watch timer, and the LCD
controller/driver. 8-bit timer 50, the watch timer, and the LCD controller/driver can therefore keep
running even during standby. The other hardware stops when the main system clock stops because it
runs based on the main system clock (except for external input clock operations).