NEC PX-60SP3U Attaching speakers to a plasma monitor, Note, 12 mm) (8 locations), Loosely screw the screws (M5, locations indicated in the diagram below

Attaching speakers to a plasma monitor

The speakers are divided into a right (R) and left (L) speaker.

When attaching the speakers, be sure to check the labels located on the rear of the speakers as well as the markings (R/L) written on the attachment plates.

1 Remove the protective tape from the cushions and then	2 Attaching the attachment pieces to the locations shown
attach the cushions to the sides of the speakers in the	in the drawing of the plasma monitor with screws (M5 ⋅
locations indicated in the diagram below.	12 mm) (8 locations).
	Check the marks on the attachment pieces (TL, TR, BL,
	BR) and the plasma monitor attachment locations.

English

Cushions

3 Loosely screwing the screws (M5 ⋅ 12 mm) into place on the top attachment pieces (2 locations).

Note

To install the plasma monitor on a wall, first attach the attachment pieces to the plasma monitor then install it on the wall. After installing the plasma monitor on the wall, it may be impossible to tighten the screws on the attachment pieces.

4 1 Attaching the screws (M5 ⋅ 12 mm) that have been loosely screwed into place on the hooks on top of the speakers.

2Loosely screw the screws (M5 ⋅ 12 mm) into place with the screw holes on the attachment pieces on the bottom aligned with the holes in the hooks on the bottom of the speakers.

3