203 Eng Fr Cndn manual 12/21/98 11:20 AM Page 11
Step 6 Locate the two screws that are supplied with the IntelliBase
and attach the IntelliBase™ to the adapter plate and monitor as shown in
Figure 3E.
Figure 3E
INTELLIBASE (BOTTOM VIEW)
Proceed to Page 10 to connect your MultiSync® monitor with IntelliBase USB Hub and Audio to your system.
MultiSync Monitor Model Names
MultiSync XE21, XP21, E1100, E1100+, P1150 and P1250+
FOR ALL 21” MULTISYNC MONITORS
IT IS ADVISED THAT TWO PEOPLE ARE INVOLVED DURING THE ENTIRE INSTALLATION PROCESS. ONCE THE INTELLIBASE HAS BEEN INSTALLED ONTO YOUR 21” MONITOR, DO NOT ATTEMPT TO ADJUST THE TILT OF THE MONITOR FROM THE BACK OF THE MONITOR UNIT. ONLY ADJUST THE TILT FROM THE FRONT OF THE UNIT BY HOLDING ONTO THE LEFT AND RIGHT SIDE OF THE MONITOR, TILTING EITHER UPWARDS OR DOWNWARDS. DO NOT TILT THE MONITOR DOWNWARDS MORE THAN 5 DEGREES OR FORCE THE MONITOR PAST THE FIRST STOP, AS THE MONITOR MAY BECOME UNSTABLE, CAUSING POSSIBLE INJURY.
If you have any questions or comments, please contact NEC at
Step 1 With the monitor unplugged from your system and wall outlet, carefully turn the monitor upside down onto a firm table so that the base is facing up as shown in Figure 1.
MONITOR IN POSITION TO
REMOVE THE BASE AND ATTACH INTELLIBASE USB HUB AND AUDIO
BASE
Figure 1
7
