3. Projecting an Image (Basic Operation)

Note on Startup screen (Menu Language Select screen)

When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one of the 8 menu languages.

To select a menu language, follow these steps:

1. Use the SELECT or button to select one of the 8 languages for the menu.

LAMP

 

 

STATUS

 

 

POWER

VIDEO

S-VIDEO COMPUTER-1 COMPUTER-2

2. Press the ENTER button to execute the selection.

SELECT

ON/STAND BY

AUTO

ADJ.

OFFON

POWER

MAGNIFY PIC-MUTE PAGE

UP

DOWN

MENU

ENTEREXIT

LAMP

 

 

STATUS

 

 

POWER

VIDEO

S-VIDEO COMPUTER-1 COMPUTER-2

SELECT

ON/STAND BY

After this has been done, you can proceed to the menu opera- tion.

If you want, you can select the menu language later. See "Lan- guage" on pages 35 and 41.

AUTO

ADJ.

OFFON

POWER

MAGNIFY PIC-MUTE PAGE

UP

DOWN

MENU

ENTEREXIT

NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.

When the Lamp mode is set to Eco, the LAMP indicator will light green.

If one of the following things happens, the projector will not turn on.

If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal components to cool down.

When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.

If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and then turn on the power.

22

Page 29
Image 29
NEC VT470 manual Projecting an Image Basic Operation, To select a menu language, follow these steps