3. Projecting an Image (Basic Operation)Note on Startup screen (Menu Language Select screen)

When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one of the 8 menu languages.

To select a menu language, follow these steps:1.Use the SELECT  or  button to select one of the 8 languages from the menu.

 

 

MENU

 

2

SELECT

 

1

 

ENTER

LAMP

 

STATUS

POWER

ON/STAND BY SOURCE

 

OFF

 

ON

 

 

POWER

 

 

MAGNIFY

PIC-MUTE

PAGE

 

 

 

UP

 

 

 

DOWN

EXIT

 

 

 

 

MENU

 

 

 

2

1

 

AUTO ADJ.

ENTER

 

EXIT

2. Press the ENTER button to execute the selection.

After this has been done, you can proceed to the menu op- eration.

If you want, you can select the menu language later. (→ [Language] on page 38 and 43)

NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp lighting is stabilized.

When the Lamp mode is set to Eco, the LAMP indicator will light green.

If one of the following things happens, the projector will not turn on.

•If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal components to cool down.

•When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.

•If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and then turn on the power.

20