5. Using On-Screen Menu

Enabling Power Management [Power Management]

When this option is selected you can enable the projector to automatically turn off (at the selected time: 5 min., 10 min., 20 min., 30 min.) if there is no signal received by any input.

Enabling Fan Speed Mode [Fan Mode]

This option allows you to select three modes for fan speed: Auto mode, High speed mode, and High Altitude mode.

Auto ......................

The built-in fans automatically run at a variable speed according to the internal temperature.

High ......................

The built-in fans run at a fixed high speed.

High Altitude .........

The built-in fans run at a high speed. Select this option when using the projector at altitudes approximately

 

5500 feet/1600 meters or higher.

When you wish to cool down the temperature inside the projector quickly, select [High].

NOTE:

•It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.

•Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to [High Altitude] can cause the projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.

•Using the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [High Altitude] can cause the lamp to overcool, causing the image to flicker. Switch [Fan Mode] to [Auto].

•Your setting will not be affected even when [Reset] is done from the menu.

Selecting Default Source [Default Source Select]

You can set the projector to default to any one of its inputs each time the projector is turned on.

Last .......................

Sets the projector to default to the previous or last active input each time the projector is turned on.

Auto ......................

Searches for an active source in order of Computer 1 → Computer 2 (Digital) → Computer 2 (Analog) →

 

Video → S-Video → Computer 1 and displays the first found source.

Computer 1 ...........

Displays the RGB source from the COMPUTER 1 IN connector every time the projector is started up.

Computer 2 (Digital) ...

Displays the DVI digital source from the COMPUTER 2 IN connector every time the projector is started up.

Computer 2 (Analog) ..

Displays the RGB source from the COMPUTER 2 IN connector every time the projector is started up.

Video .....................

Displays the Video source from the VIDEO IN connector every time the projector is started up.

S-Video .................

Displays the Video source from the S-VIDEO IN connector every time the projector is started up.

Selecting Signal Format [Signal Select]

[Computer 1],[Computer 2 (Analog)]

Allows you to choose [Computer 1], or [Computer 2 (Analog)] for an RGB source such as a computer, or [Component] for a component video source such as a DVD player. Normally select [RGB/Component] and the projector automatically detects a component signal. However there may be some component signals that the projector is unable to detect. If this is the case, select [Component].

[Video & S-Video System Select]

This feature enables you to select composite video standards automatically or manually. Normally select [Auto] and the projector will automatically detect the video standard.

In the case where the projector has difficulty detecting the video standard, select the appropriate video standard from the menu.

This must be done for Video and S-Video respectively.

Enabling the deinterlace [Deinterlace]

Turns on or off the deinterlace function for a telecine signal.

On .........................

Default standard setting.

Off .........................

Select this option if there is any jitter or artifacts in video.

NOTE: This feature is not available for RGB, 480p, 576p and HDTV signals.

45