NetComm NP642 manual Connecting the Antenna, You have screwed it all the way to its end

Connecting the Antenna

Before continuing with the Software Installation section, you will need to connect the antenna

1.The antenna has a retaining nut which must be screwed into the connector on the back of the card. Place the screw retaining nut over the antenna connection on the rear of the NB642 and turn it clockwise.

Bend

antenna to a 90o angle

Screw

retaining nut

clockwise

over the antenna connection

Note:	Do not over-tighten the attaching nut - but do make sure that
	you have screwed it all the way to its end.

2. Adjust the antenna to a 90o angle.

Note:	Please note that you may have to rotate the complete antenna
	assembly to do this and have the antenna pointing vertically.

NP642 IEEE 802.11g PCI Adapter	11
YML785 Rev1