NETGEAR 2409 manual Connecting the Antenna for an Indoor Installation

Installation Guide for the 9 dBi Omni-directional Antenna ANT2409

Connecting the Antenna for an Indoor Installation

1.Turn off your wireless unit.

2.In the procedure “First, Assemble and Mount the Antenna” on page 2-2, the antenna should have been assembled for indoor installation using a NETGEAR cable ACC-10314-01, 02, 03, 04 or 05 and the reverse N/SMA adaptor connected to the antenna. The provided 2m cable should not have been used.

D"ID/MNI$IRECTIONAL !NTENNA !.4

!TTACHAUSING

2EVERSE .3-! ADAPTER

.%4'%!2 ANTENNA CABLE	7IRELESSE!CCESSS0OINT
0URCHASED SEPARATELY

$OONOT

REMOVE

!NTENNA

#ONNECTION

6$#

0RIMARY

%4(%2.%4

2%3%4

3ECONDARY

Figure 2-3: Antenna Assembly Installation Indoors

3.Locate the primary detachable antenna. Remove the antenna and connect the other end of the NETGEAR cable ACC-10314-01, 02, 03, 04 or 05 to this port.

NOTE: On access points with two antennas, if you are only replacing one antenna, be sure to replace the primary antenna and do not remove the secondary antenna.

4.After attaching your new 9dBi antenna, reconnect your wireless device to the network and turn it on.

Installing the 9 dBi Omni-directional Antenna 2-5